Common Postscript Problems - Xerox Phaser 3052NI User Manual

Condition
Horizontal stripes If horizontally aligned black lines, stripes, streaks or smears appear:
• The toner cartridge may not be installed properly. Remove the cartridge and reinsert
A a B b C
A a B b C
• The toner cartridge may be defective. Remove the toner cartridge and install a new
A a B b C
A a B b C
• If the problem persists, the machine may require repair. Contact a service
A a B b C
An unknown image • Your machine is probably being used at an altitude of 1,500 m (4,921 ft) or above.
repetitively
appears on a few
sheets, or loose
toner, light print, or
contamination
occurs.

Common PostScript Problems

The following situations are PS language specific and may occur when several printer languages are
used.
Problem
PostScript file cannot be printed.
Limit Check Error report prints.
A PostScript error page prints.
it.
one. (See Replacing the Toner
representative.
The high altitude may affect the print quality, such as loose toner or light imaging.
Change to the correct altitude setting for your machine. (See
Possible Cause
The PostScript driver may not be
installed correctly.
The print job was too complex.
The print job may not be
PostScript.
Suggested Solutions
Cartridge.)
• Install the PostScript driver.
(See
• Print a configuration page and
verify that the PS version is
available for printing.
• If the problem persists, contact
a service representative.
• You might need to reduce the
complexity of the page.
• Make sure that the print job is
a PostScript job. Check to see
whether the software
application expected a setup
or PostScript header file to be
sent to the machine.
Xerox® Phaser® 3052/3260
Common Problems
System Setup.)
Solution
Install Printer Software.)
145
User Guide