Xerox Phaser 3052NI User Manual page 136

Common Problems
Condition
Wrinkles or creases • Ensure that the paper is loaded properly.
• Check the paper type and quality. (See
• Turn the stack of paper over in the tray. Also try rotating the paper 180 degrees in
Back of printouts Check for leaking toner. Clean the inside of the machine. (See
are dirty
Solid Black pages • The toner cartridge may not be installed properly. Remove the cartridge and reinsert
• The toner cartridge may be defective. Remove the toner cartridge and install a new
A
• The machine may require repair. Contact a service representative.
Loose toner • Clean the inside of the machine. (See
• Check the paper type and quality. (See
• Remove the toner cartridge and install a new one. (See
• The machine may require repair. Contact a service representative.
Character Voids Character voids are white areas within parts of characters that should be solid black:
• If you are using transparencies, try another type of transparency. Because of the
A
• You may be printing on the wrong surface of the paper. Remove the paper and turn
• The paper may not meet paper specifications. (See
144 ® ®
Xerox Phaser
User Guide
the tray.
it.
one. (See Replacing the Toner
Cartridge.)
composition of transparencies, some character voids are normal.
it around.
3052/3260
Suggested Solutions
Media Guidelines.)
Cartridge.)
Cleaning the Machine.)
Media Guidelines.)
Media
Cleaning the Machine.)
Replacing the Toner
Specifications.)