Recordex TechDisc Pro User Manual page 34

User's Guide
Press a Key to Eject Good Disc.
Press any key to eject the good disc after copying.
Read disc error
During comparison the disc could not read.
Save new config Fail!
The settings could not be saved.
Source Disc Empty!!!
The source disc does not contain any data.
Source Disc Not Ready
The source disc is not ready to be read.
Source Drive Not Ready
The source drive is not ready to read the disc.
Src&Tgt can't in the same channel
During comparison the source and target discs cannot be in the same channel.
Target Disc Not Empty!!!
The duplicator detected non-blank media in the target drive.
Target Disc Not Ready
The target disc is not ready to be written to.
Target Drive Not Ready
The target drive is not ready to write.
Target overflow
The target disc's blank capacity is smaller than the source image.
TOC not match
The TOC did not match when the images were compared.
User Abort!
The operation was canceled by the user.
2. Operating with a Hard Drive
All data will be lost, format?
All data on the hard disk will be lost. Confirm the formatting of hard disk.
Delete Image in Partition xx?
Confirm the deletion of the data image in partition xx.
Format HDD?
Confirmation that you want to format the hard disk.
Format HDD OK!
The hard disk has been formatted.
HDD not Format!
The hard disk has not been formatted.
HDD too small
The capacity of hard disk is too small for the image being loaded.
HDD too small to handle image!
The hard disc partition is too small store the data image
©2007 Recordex USA, Inc. All rights reserved.
Version: 1.2
TM
®
Recordex TechDisc Pro CD
34