Recordex TechDisc Pro User Manual page 14

User's Guide
In chapter 4 we discussed the Copy function (1.Copy) and the Image function (9.Image). In this chapter you will be intro-
duced to the rest of the functions built into your duplicator's control panel.
Test
The test function, 2. Test, provides you with a way to simulate a disc copy. This is sometimes useful if you are not sure if
your master disc may be too big for the target disc (I.e. Target over flow). In any case the test function works just like the
copy function except no data is actually written to the target drives.
2
Note, although data isn't written to the target drives it is still necessary to use good quality blank discs for the test.
First, set the duplicator to test mode. To do this simply scroll through the controller menu until you find the test function. The
LCD panel should look like this:
Test Function
After you have set the controller to test mode you are ready to load blank media into the target drives. Once you have
loaded all of the blank media press ENT to start the test process. The LCD panel will display the status of the test and indi-
cate the estimated time left for the test. The controller will display the following:
Successful Test Copies
After the test process is complete the successfully tested discs will be ejected. This makes it easier to identify which discs
passed and which discs failed the test. This is a user selectable feature and can be changed through the Setup menu by
changing the setting under the Eject Disc sub-menu.
©2007 Recordex USA, Inc. All rights reserved.
Version: 1.2
Figure 5.1
2. Test
Figure 5.2
Preparing......
Check Target
Please Wait
Source
Test-A-18X
1/1 Trk
12. Test
OK: 07
P:A
The source is set to
4380MB
Partition A.
The image on partition A is 4380MB.
% Complete
5%
Estimated time remaining
6:50
TM
®
Recordex TechDisc Pro CD
14