Recordex TechDisc Pro User Manual page 18

User's Guide
Prescan
The Prescan function, 6. Prescan, provides a way to test the readability of a source disc. The duplicator will read the
source disc and report the status of the read process. To prescan a source disc set the host duplicator to Prescan mode. To
do this simply scroll through the controller menu until you find the Prescan function. The LCD panel should look like this:
Prescan Function
The Prescan function checks the source disc so you will want to first make sure that you have selected the source you wish to
pre-scan. For information on selecting a source see section Select Source later in this chapter. Once you have loaded and
selected a source disc press ENT to start the Prescan process. The LCD panel will display the status of the Prescan test and
indicate the estimated time left for the test. The controller will display the following:
©2007 Recordex USA, Inc. All rights reserved.
Version: 1.2
Figure 5.9
6. Prescan
4380MB
The source image is 4380MB.
Figure 5.10
Preparing......
Scanning-18X 5%
1/1 Trk 6:50
Prescan OK!
®
Recordex TechDisc Pro
Blank indicates the source
is set to a disc drive, if a hard
drive is selected then a partition
will be reported, I.e. P:A
* See Select Source for more info.
% Complete
Estimated time remaining
TM
CD
18