Making Connections - Recordex TechDisc Pro User Manual

User's Guide
Taking a minute to make sure that your TechDisc Pro2100™ duplicator is setup properly will make operation smoother and
more enjoyable.
Contents
First, un pack all three boxes and verify the contents of your system against the list below.
Location
Next, pick a well suited location to setup your duplicator. You should choose a level and stable work surface in an area
with good ventilation, moderate temperature and humidity, and access to a grounded power outlet.
i
Consider using an uninterruptible power supply with surge protection (UPS) to protect your duplicator.

Making Connections

1. Connect the power cable to the back of the unit and to the power
source (I.e. Surge protector, UPS, or grounded wall outlet).
2. Turn the unit on using the power switch located on the back of the
unit.
Powering On
The control panels should look like this after you've powered on the unit:
1. Copy
NOTE: When you power on the duplicator it will run a short self-diagnostic test during which time the LCD panel
2
look very different from the image above. This is normal and after about 20 seconds the test will be complete and
the LCD panel will look like the reference image above.
©2007 Recordex USA, Inc. All rights reserved.
Version: 1.2
ü
Duplicator
P:A
ü
ü
Manual
Power cable
®
Recordex TechDisc Pro
ü
Quick Start Guide
TM
CD
10