Recordex TechDisc Pro User Manual page 16

User's Guide
Verify
The Verify function, 4. Verify, provides a way to verify that a copied disc will read properly in a standard CD or DVD
player.
To verify a disc or set of discs set the duplicator to Verify mode. To do this simply scroll through the controller menu until
you find the Verify function. The LCD panel should look like this:
Verify Function
After you have set the controller to Verify mode you should load copied discs into the target drives. Once you have load-
ed all of the copied discs press ENT to start the Verify process. The LCD panel will display the status of the verify test and
indicate the estimated time left for the test. The controller will display the following:
Successfully Verified Discs
After the test process is complete the successfully verified discs will be ejected. This makes it easier to identify which discs
passed and which discs failed. This is a user selectable feature and can be changed through the Setup menu by changing
the setting under the Eject Disc sub-menu.
i
Note: The system can only verify multiple discs at one time if all of the discs were copied from the same image.
©2007 Recordex USA, Inc. All rights reserved.
Version: 1.2
Figure 5.5
4. Verify P:A
4380MB
The image on partition A is 4380MB.
Figure 5.6
Preparing......
Verify- 18X
1/1 Trk 6:50
4. Verify
OK: 07
Recordex TechDisc Pro
The source is set to
Partition A.
% Complete
5%
Estimated time remaining
TM
®
CD
16