Recordex TechDisc Pro User Manual page 17

User's Guide
Compare
The Compare function, 5. Compare, provides a way to compare a copy disc to the source image. The duplicator will make
the comparison and then report whether the discs are identical or not.
To compare a disc or set of discs set the duplicator to Compare mode. To do this simply scroll through the controller menu
until you find the Compare function. The LCD panel should look like this:
Verify Function
After you have set the controller to Compare mode you should load copied discs into the target drives. Once you have
loaded all of the copied discs press ENT to start the Compare process. The LCD panel will display the status of the Com-
pare test and indicate the estimated time left for the test. The controller will display the following:
Source Partition
(what the copies are being
compared with)
Discs that failed
Press ENT to display detailed
results for each disc.
Src:05 HDD
Total: 4380MB
Info about source image/disc
After the test process is complete the successfully compared will be ejected. This makes it easier to identify which discs
passed and which discs failed. This is a user selectable feature and can be changed through the Setup menu by changing
the setting under the Eject Disc sub-menu.
©2007 Recordex USA, Inc. All rights reserved.
Version: 1.2
Figure 5.7
5. Compare
Figure 5.8
Preparing......
Comp-A- 18X
1/1 Trk
Compare
FAIL: 1
ENT
Tgt:00
P: B
Identical
Info about target disc (passed)
P:A
4380MB
The image on partition A is 4380MB.
5%
6:50
OK: 5 Successfully Verified Discs
DIFF: 1 Discs with differences
ENT
SUPER MUL
Tgt:01
TOC not match
Info about target disc (failed)
®
Recordex TechDisc Pro
The source is set to
Partition A.
% Complete
Estimated time remaining
ENT
SUPER MUL
TM
CD
17