Test & Copy - Recordex TechDisc Pro User Manual

User's Guide
Test & Copy
The Test & Copy function, 3. Test & Copy, provides you with a way to simulate a disc copy before creating an actual
copy. Essentially, this function first runs a test cycle and if the test cycle is good then a copy is made, if the test cycle fails
the duplicator does not attempt to make a copy of the source image.
First, set the duplicator to Test & Copy mode. To do this simply scroll through the controller menu until you find the Test &
Copy function. The LCD panel should look like this:
After you have set the controller to Test & Copy mode you are ready to load blank media into the target drives. Once you
have loaded all of the blank media press ENT to start the test process. The LCD panel will display the status of the test
and indicate the estimated time left for the test. The controller will display the following:
Successful Test Copies
After the test process is complete the successfully tested discs will be ejected. This makes it easier to identify which discs
passed and which discs failed. This is a user selectable feature and can be changed through the Setup menu by changing
the setting under the Eject Disc sub-menu.
©2007 Recordex USA, Inc. All rights reserved.
Version: 1.2
Figure 5.3
3. Test&Copy
Test & Copy Function
Figure 5.4
Preparing......
Check Target
Please Wait
Source
Test-A-18X
1/1
Copy-A-18X
1/1
3. Test & Copy
OK: 07
P:A
4380MB
The image on partition A is 4380MB.
5%
Trk 6:50
5%
Trk 6:50
®
Recordex TechDisc Pro
The source is set to
Partition A.
% Complete
Estimated time remaining
TM
CD
15