Loading The Film Holder; Loading The 35Mm Film Holder - Fh-U1 - Minolta Dimage Scan Elite II Instruction Manual

2. LOADING THE FILM HOLDER

Using the included holders, the DiMAGE Scan Elite II can scan mounted or unmounted...
• Colour negatives
• Black and white negatives
APS (Advanced Photo System) film can also be scanned using the optional APS adaptor AD-10.
CAUTION
Remove any dust from the film before placing it in the film holder. Only use brushes or com-
pressed air specifically for photographic film. Do not blow on the film with your mouth, or use tis-
sue paper or your fingers to wipe the film. Always hold the film by the edges.
LOADING THE 35MM FILM HOLDER – FH-U1
The 35mm film holder FH-U1 accommodates film strips with up to six frames. The horizontal images
should be orientated in the same direction as the frame numbers on the film holder.
1 Lift the film cover on the FH-U1 by the
tab near the number six frame.
2 Place the film in the film holder with the
emulsion down.
• If the frame numbers on the edge of the film near the
sprocket holes are reversed, the films emulsion side
is up. Turn the film over.
• Align the film frames with the holder frames.
3 Insert the two tabs on the left side of the
film cover into the holes in the holder
base. Carefully lower the cover tak-
ing care not to move the film.
Snap the film cover closed by
pressing the two "PUSH"
marks.
• Colour positives
• Black and white positives
23