Disc Inspection; Front Brake Pads - Gilera Runner RST 50 SP Service Station Manual

Runner RST 50 SP
Refitting
-When refitting, position the disc correctly making sure that it rotates in the right direction.
Locking torques (N*m)
Disc tightening screw 8 - 12

Disc Inspection

•
Use the micrometer to check the thick-
ness of the disc as shown in the pho-
tograph
Characteristic
Standard thickness:
4 +02-01mm
•
Using the appropriate tool, measure
how much the disc protrudes when the
wheel is fitted properly. The protrusion,
measured near the external edge of
the disc, must be less than 0.1 mm.
•
If a value is measured other than the
specified value, remove the front wheel
(Front/Rear Suspension chapter) and
check the protrusion of the disc. Maxi-
mum permissible out of true is 0.1 mm.
If the value measured is greater, re-
place the disc and repeat the check.
•
If the problem persists, check and re-
place the wheel hub if necessary.
Specific tooling
020335Y Magnetic support for dial gauge

Front brake pads

Braking system
BRAK SYS - 113