Table of Contents
Advertisement
9
9.2
Getting Ready
9.2.1
Connecting to a LAN Network
This copier supports the TCP/IP protocol used by LAN networks. In order
to use this protocol, the copier must be connected to the LAN with a
network cable.
Connecting the LAN Cable
Insert the connector on one end of the LAN cable into the network port
(marked LAN) on the back of the copier, and the connector on the other
end to an open port on a network hub.
Tip
The network port is on the back of the copier.
Use a Category 5 or 5E LAN cable.
The LAN cable is not included.
LED1
9-14
LED2
9.2 Getting Ready
Advertisement
Table of Contents
