NEC NEFAX 671 User Manual page 236

8.8 What Does Each Message Mean?
Message
LINE PROBLEM
(Flashing alternately)
CHECK LINE
∗ ∗
COMM.ERROR
∗ ∗
REDIAL ALL FAILED
∗
MEM.FULL/TX CANCEL
∗
MEM.FULL/RX CANCEL
FILE FULL/TX CANCEL
FILE FULL/RX CANCEL
HANG UP THE PHONE
×
TEXT 1.00 1
ä[A]ü #XXX: EMPTY
×
TEXT 1.00 1
ä[A]ü #XXX Fax Err
×
TEXT 1.00 1
ä[A]ü#XXComm.Err
Cause
• The telephone dialing
system or telephone wiring
system are not set correctly.
• The telephone cable is not
attached correctly.
• Communication is not
(####) possible because of some
problem in the machine.
• Communication is not
possible because of a
problem with the recipient/
caller's fax machine.
All redial attempts failed
because either the recipient's
line is busy or there was no
answer.
∗
While sending a fax, the size of
the data for the scanned image
has exceeded the capacity of
the memory.
∗
While receiving a fax, the size
of the data for the received
image has exceeded the
capacity of the memory.
While sending a fax, the
maximum of number of
managed memory file is used.
While receiving a fax, the
maximum of number of
managed memory file is used.
The receiver of the connected
telephone is lifted.
(While specifying copy settings)
The selected paper tray has run
out of paper.
"#" indicates the paper tray, and
"XXX" indicates the paper size.
A fax error occurred while an
operation was being performed
in Copy mode.
A fax transmission error
occurred while an operation
was being performed in Copy
mode.
Action
• Check the telephone dialing
system or telephone wiring
system and use the
appropriate Utility mode
function to make the correct
settings.
• Correctly connect the
telephone cable.
Check the transmission results.
Check the condition of the
recipient's line, and then try
sending the fax again.
• Retrieve all received faxes
stored in the memory.
• Send the fax by direct
transmission.
Retrieve all received faxes
stored in the memory.
Retrieve all received faxes
stored in the memory.
Retrieve all received faxes
stored in the memory.
Replace the receiver of the
connected telephone on the
hook.
Either load paper of the
specified size into the specified
paper tray, or press the [Paper]
key and select a different paper
size.
Press the [Fax] key to check the
error condition, and take
appropriate measures.
Press the [Fax] key to check the
error condition, and take
appropriate measures.
8
8-23