Removing The Filter Housing - Whirlpool LHW0050PQ Service Manual

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Open the filter door.
4. Turn the filter counterclockwise 90° and
pull it out of the housing.
5. Remove the two filter housing screws.
Filter Housing Screws
Housing
Filter

REMOVING THE FILTER HOUSING

6. Lay the washer on a protected surface
with the front side down.
7. Remove the eight screws from the bottom
panel and remove the panel from the
washer.
8. From the bottom of the washer, loosen the
three hose clamps on the hoses that are
attached to the filter housing, and pull the
hoses off the housing.
9. Remove the filter housing from the washer.
Filter Housing
4-18
Bottom Panel
(8 Screws)
3 Hoses