Location Requirements - Whirlpool LHW0050PQ Service Manual

LOCATION REQUIREMENTS

Selecting the proper location for your washer
improves performance and minimizes noise
and possible washer "walk."
The washer can be installed in a basement,
laundry room, closet, or recessed area (see
"Drain System").
IMPORTANT: Do not install or store the washer
where it will be exposed to the weather.
Proper installation is your responsibility.
You Will Need
• A water heater set to deliver 120°F (49°C)
water to the washer.
• A grounded electrical outlet located within
5 ft (1.5 m) of where the power cord is
attached to the back of the washer (see
"Electrical Requirements").
• Hot and cold water faucets located within
3-1/2 ft (1.1 m) of the hot and cold water fill
valves, and water pressure of 5-100 psi
(34.5-690 kPa).
• A level floor with a maximum slope of 3/4"
(1.9 cm) under entire washer. Installing the
washer on carpeting is not recommended.
• A sturdy floor to support the washer weight
(washer, water and load) of 260 lbs (118 kg).
• Do not store or operate your washer in
temperatures at or below 38°F (3.33°C).
Some water can remain in the washer and
can cause damage in low temperatures.
Recessed Area Or Closet Installation
The dimensions shown are for the recom-
mended spacing allowed, except the closet
door ventilation openings. The dimensions
shown for the closet door ventilation openings
are the minimum required.
23-3/8"
(59.37 cm)
Front View
• Additional spacing should be considered for
ease of installation and servicing.
• Additional clearances may be required for
wall, door and floor moldings.
• Additional spacing of 1" (2.5 cm) on all sides
of the washer is recommended to reduce
noise transfer.
• If a closet door is installed, the minimum air
openings in the top and bottom of the door
are required. Louvered doors with air open-
ings in the top and bottom are acceptable.
• Companion appliance spacing should also
be considered.
2-2
23-1/8"
(58.74 cm)
Side View Closet Door With Vents