Washer Care - Whirlpool LHW0050PQ Service Manual

24'' front-loading automatic washer
Hide thumbs Also See for LHW0050PQ:
Table of Contents

Advertisement

CLEANING THE WASHER
WARNING: Before performing the operations
described below, make sure that the power is
off and the unit is unplugged.
Cleaning The Exterior
Use a soft damp cloth or sponge to wipe up any
spills. Occasionally wipe the outside of the
washer to keep it looking new. Use mild soap
and water. Do not use abrasive products.
Cleaning The Interior
Use a soft damp cloth or sponge to occasion-
ally wipe the inner door to remove any deter-
gent residue. Use mild soap and water. Do not
use abrasive products.
Cleaning The Door Seal
Use a soft damp cloth or sponge when neces-
sary. Check the fold of the seal periodically for
any foreign objects.
Cleaning The Dispenser Drawer
The dispenser drawer is removable for easy
cleaning.
1. Unlock the dispenser drawer by pressing
on the plastic part of the softener compart-
ment marked "PUSH." See "Using the Dis-
penser."
2. Remove the drawer.
3. Do not clean the door with cleaning sol-
vents or abrasive cleansers. You could
damage the finish.
4. Replace the inserts and return the dis-
penser to the drawer.
Cleaning The Lint Filter
The lint filter should be cleaned about once a
month. Make sure the washer has drained
before opening the filter door.

WASHER CARE

1. Place a pan or towel under the filter door,
since a small amount of water could spill.
2. Remove the filter by rotating it a half-turn
counterclockwise and pulling outwards.
3. Clean the filter with a soft brush under
running water until all residue is removed.
4. Replace the filter and turn it clockwise until
it is securely locked in place. Give the cap
a gentle tug to confirm that the filter is in
securely.
Cleaning The Control Panel
To clean the control panel, use only a warm,
damp cloth.
NOTE: To prevent penetration of liquid into the
door lock and electrical components:
• Do not spray water or cleaning solvents on
the control panel.
• Do not use abrasive cleaners or scouring
pads on the outer surfaces because they will
scratch the finish and could remove the
writing on the control panel.
• Some paper towels may also scratch the
finish.
3-8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents