Whirlpool LHW0050PQ Service Manual page 27

7. To remove the spin speed or wash
selector switch:
a) Pull the knob off the switch shaft.
b) Remove the two screws from the com-
ponent cover and remove the cover.
2 Screws
Component
c) Lift the locking tab on the selector
switch board connector, and pull the
connector off the switch board.
d) Remove the two mounting screws from
the selector switch and remove the
switch from the control panel.
Wash Selector
Switch Connector
2 Screws
e) Lift the selector switch out of its hous-
ing.
Selector
Switch
Switch
Housing
Cover
Spin Speed Selector
Switch Connector
2 Screws
8. To remove the LED board:
a) Remove the component cover (see
step 7).
b) Remove the two mounting screws from
the LED board and remove the board
from the control panel.
LED Board (2 Screws)
c) Pull the ribbon cable connector off the
board connector and remove the board.
Ribbon Cable
LED
Board
Continued on the next page.
4-3