Basic Configuration Examples; Example 1: Defining An Ssid - Black Box LWN602A User Manual

8. Basic Configuration Examples

This chapter introduces the SmartPath EMS GUI in Enterprise mode through a series of examples showing how to create a basic
configuration of an SSID, cluster, and WLAN policy. It then explains how to connect several SmartPath APs to SmartPath EMS,
accept them for management, and push the configuration to them over the network.
NOTE: Although maps provide a convenient method for organizing and managing your SmartPath AP deployment, they are not
strictly required and are not covered in this chapter. For information about using maps, see Section 9.1.
You can look at any of the following examples individually to study how to configure a specific feature or view all of them
sequentially to understand the basic workflow for configuring and managing SmartPath APs through SmartPath EMS.
The examples are as follows:
• Section 8.1, Example 1: Defining an SSID: Define the security and network settings that wireless clients and SmartPath APs use
to communicate.
• Section 8.2, Example 2: Creating a Cluster: Create a cluster so that the SmartPath APs can exchange information with each
other to coordinate client access, provide best-path forwarding, and enforce QoS policy.
• Section 8.3, Example 3: Creating a WLAN Policy: Define a WLAN policy, which contains the SSID and cluster defined in the first
two examples.
• Section 8.4, Example 4: Connecting SmartPath APs to SmartPath EMS: Cable two SmartPath APs to the network to act as
portals and set up a third one as a mesh point. Put the SmartPath APs on the same subnet as SmartPath EMS and allow them
to make a CAPWAP connection to SmartPath EMS.
• Section 8.5, Example 5: Assigning the Configuration to SmartPath APs: Assign the WLAN policy to the SmartPath APs. Also,
change SmartPath AP login settings and—if necessary—country codes.
Figure 8-1. The conceptual relationships among the configuration examples in this chapter.
In the first three examples, you define configuration objects in the Configuration section of the GUI. In the last two examples, you
connect some SmartPath APs to the network, enable them to make a CAPWAP connection to SmartPath EMS, and then manage
them in the Monitor section of the GUI.

8.1 Example 1: Defining an SSID

A service set identifier (SSID) is an alphanumeric string that identifies a group of security and network settings that wireless clients
and access points use when establishing wireless communications with each other. In this example, you define the following SSID,
which uses a preshared key (PSK) for client authentication and data encryption:
SSID name: test1-psk
SSID access security: WPA/WPA2 PSK (Personal)
Preshared key: CmFwbo1121
Chapter 8: Basic Configuration Examples
724-746-5500 | blackbox.com
Physical devices on the network
Configuration
The conceptual relationships among the
configuration examples in this chapter.
Page 77