Black Box LWN602A User Manual page 44

Chapter 3: The SmartPath AP (LWN602HA) Overview
Wrap the wire around a beam, clip the hook to the rope, and
then pull the rope downward until it is taut against the beam. 3
Wrap the wire rope around a beam, clip the hook to the rope, and
then pull the rope downward until it is taut against the beam.
Beam
6. Attach antennas to the antenna connectors on the SmartPath AP, connect one or two Ethernet cables to the network, and—
if not using PoE—connect the power cord to a power source.
Height Correction
If you accidentally pull too much wire rope through the locking device, raising the SmartPath AP too high, and you then need to
lower it, do the following: Take a tool, such as a screwdriver with a
opposite direction from the arrow on the outside of the locking device (see Figure 3-21). This releases its grip on the rope,
enabling you to pull out the rope the same way it was inserted. While maintaining pressure on the tube, adjust the rope until the
SmartPath AP is at the height you want. When you are satisfied, stop pressing against the tube so that it can regain its grip on
the rope.
Page 44
Push the wire rope through
the side hole in the locking
4
device, and continue pulling the
Push the wire rope through the
side hole in the locking device
rope to raise the SmartPath AP
and then through the loop in the
to the height you want.
quad-toggle.
Pass the wire rope upward through
5
Pass the wire rope upward through the
the center hole in the locking device,
center hole in the locking device, and
and continue pulling the rope to raise
continue pulling the rope to raise the
HiveAP 340 to the height you want.
the SmartPath AP to the height you want.
Locking Device
Locking Device
Clip Clip
Quad Toggle
Pull downward
Pull downward Mounting Plate
Mounting Plate
on the rope. on the rope.
SmartPath AP
(LWN602HA)
Figure 3-20. Suspending the SmartPath AP.
Locking Device
Locking Device
Wire Rope
Wire Rope
While pushing the tube inward, pull the rope out.
While pushing the tube inward, pull the wire rope out.
Figure 3-21. Releasing the wire rope from the locking device.
724-746-5500 | blackbox.com
Quad-Toggle
HiveAP 340
⁄ " flat tip, and press it against the lip of the inner tube in the
1
8
Press against the lip
of the inner tube and
Press against the lip of
the inner tube and hold.
hold.
Screwdriver
Screw Driver
Locking
Locking
Device Device
Loop at Top of
Loop at Top of
Quad-Toggle
Quad Toggle