Black Box LWN602A User Manual page 154

Chapter 11: Deployment Examples CLI
Step 4: Configure SmartPath AP-2 and SmartPath AP-3.
1. Log in to SmartPath AP-2 through its console port.
2. Configure SmartPath AP-2 with the same commands that you used for SmartPath AP-1:
qos classifier-map oui 00:12:3b qos 6
service mms tcp 1755
service smtp tcp 25
service pop3 tcp 110
qos classifier-map service mms qos 5
qos classifier-map service smtp qos 3
qos classifier-map service pop3 qos 3
qos classifier-profile employee-voice mac
qos classifier-profile employee-voice service
qos classifier-profile eth0-voice mac
qos classifier-profile eth0-voice service
ssid employee qos-classifier employee-voice
interface eth0 qos-classifier eth0-voice
For SmartPath APs supporting IEEE 802.11a/b/g:
qos policy voice qos 5 wrr 20000 90
qos policy voice qos 3 wrr 54000 60
For SmartPath APs supporting IEEE 802.11a/b/g/n:
qos policy voice qos 6 strict 512 0
qos policy voice qos 5 wrr 20000 90
qos policy voice qos 3 wrr 1000000 60
user-profile employee-net qos-policy voice attribute 2
save config
exit
3. Log in to SmartPath AP-3 and enter the same commands.
Step 5: Configure RADIUS server attributes.
1. Log in to the RADIUS server and define the three SmartPath APs as RADIUS clients.
2. Configure the following attributes for the realm to which the wireless user accounts in network-1, -2, and -3 belong:
• Tunnel Type = GRE (value = 10)
• Tunnel Medium Type = IP (value = 1)
• Tunnel Private Group ID = 2
The RADIUS server returns the above attributes for all wireless users it authenticates from network-1, -2, and -3. The SmartPath
AP uses the combination of returned RADIUS attributes to assign users to the user group 2 ("employee-net"). It does not use
them to create a GRE tunnel, which the tunnel type attribute might lead you to think.
724-746-5500 | blackbox.com
Page 154