Set Smartpath Ap Classifiers - Black Box LWN602A User Manual

Main Office
Branch Office #1
VLAN: 10
VLAN definition: 10; type: global
SmartPath AP classifier: (nothing)
NOTE: It is assumed that the SmartPath APs have already been assigned to maps in the Topology section of the GUI.
The configuration steps are as follows:
1. Classify SmartPath APs at Branch Offices 2 and 3.
2. Create a VLAN object with three definitions for VLANs 10, 20, and 30.
3. Reference the VLAN object in a user profile that is used in an SSID that is part of the WLAN policy used by the SmartPath APs
at each branch office.
4. Update all the SmartPath APs and note how the user profile at each site has the correct VLAN definition.

9.5.1 Set SmartPath AP Classifiers

Click Monitor > Access Points > SmartPath APs (view mode: Config), and then click the column heading Topology Map to group
the managed SmartPath APs by the map to which they are assigned.
Multiselect the SmartPath APs belonging to all the maps at Branch Office 2,* click Modify, expand Advanced Settings, enter
branch2 in the Tag1 field, and then click Save.
*To multiselect all the SmartPath APs on the same map, click the first SmartPath AP assigned to a map and then SHIFT-click the
last one. This example assumes that you have used a naming convention that allows you to select SmartPath APs on multiple
maps at the same site because all the maps at that site begin with the same word, such as "branch2-floor1", "branch2-floor2",
and so on.
Multiselect the SmartPath APs belonging to all the maps at branch office 3, click Modify, expand Advanced Settings, enter
branch3 in the Tag1 field, and then click Save.
Chapter 9: Common Configuration Examples
SmartPath EMS
Figure 9-18. SmartPath AP classifiers and VLANs.
724-746-5500 | blackbox.com
Branch Office #3
VLAN: 30
VLAN definition: 30; type: branch3
SmartPath AP classifier: branch3
Branch Office #2
VLAN: 20
VLAN definition: 20; type: branch2
SmartPath AP classifier: branch2
Page 125