Surface Mount - Black Box LWN602A User Manual

With the SmartPath AP upside
4
With the HiveAP upside down, lift it
down, lift ituntil the threaded stud
until the threaded stud on the track
on the track clip enters the hole in
clip enters the hole in the HiveAP.
Revolve the HiveAP until it is
the SmartPath AP. Rotate the
securely attached to the clip.
SmartPath AP until it is securely
attached to the clip.
5. When you have the SmartPath AP in the correct location, cut or drill a hole in the ceiling through which you can then pass the
Ethernet and power cables. Pass the cables through the hole and attach them to the SmartPath AP.
6. When done, adjust the ceiling tiles back into their former position.
NOTE: You can also mount the SmartPath AP to a solid ceiling—or the underside of any horizontal object such as a cross beam—
using three #6 or #8 screws. Position the three screws in a T-shaped layout: two screws 2" (5 cm) apart from each other
and the third screw center-aligned between them and 4.75" (12 cm) away. Then attach the SmartPath AP to the screws as
explained in Section 4.5.2, Surface Mount.
Locking the SmartPath AP
To lock the SmartPath AP to a secure object, use a Kensington lock and cable. Loop the cable around a securely anchored object,
insert the Kensington lock in the device lock slot in the SmartPath AP, and engage the locking mechanism (Figure 4-7).
Device Lock Slot

4.5.2 Surface Mount

You can attach the SmartPath AP LWN602A to any flat surface that supports its weight. First, attach two screws to the surface.
Then, make a hole in the wall a few inches or centimeters above the screws so that you can pass the cables through the wall to
the SmartPath AP. Finally, attach the device to the screws, and connect the cables (see Figure 4-8).
Figure 4-6. Attaching the SmartPath AP to the track clip.
SmartPathAP mounted
to a ceiling track
Kensington Security Lock
Figure 4-7. Locking the SmartPath AP with a Kensington security lock.
724-746-5500 | blackbox.com
Chapter 4: SmartPath AP (LWN602A) Overview
SmartPathAP
Support Beam
Ceiling Track
(shown as
transparent)
Loop the cable around a secure object,
Loop the cable around a secure object, such
such as a support beam, and then insert the
as a support beam, and then insert the T-bar
T-bar component of the lock into the device
component of the lock into the device lock
lock slot on the SmartPath AP and turn the
slot on the HiveAP and turn the key to
key to engage the mechanism.
engage the lock mechanism.
\
Page 51