Black Box LWN602A User Manual page 144

Chapter 11: Deployment Examples CLI
After associating a wireless client with SmartPath AP-1, log in
to SmartPath AP-1 and enter this command:
show ssid employee station
Chan=channel number; Pow=Power in dBm;
A-Mode=Authentication mode; Cipher=Encryption mode;
A-Time=Associated time; Auth=Authenticated;
UPID=User profile Identifier; Phymode=Physical mode;
Mac Addr IP Addr
-------------- ---------- ---- -------
0016:cf8c:57bc 10.1.1.73
Total station count: 1
This MAC address is for the
wireless adapter of the client
(or "supplicant") associated
with the SSID "employee".
Then log in to SmartPath AP-2 and enter this command:
show roaming cache
Roaming Cache Table:
UID=User profile group ID; PMK=Pairwise Master Key;
TLC=PMK Time Left in Cache; Life=PMK Life; A=authenticated; L= CWP Logged In
Roaming for this SmartPath AP: enabled
Maximum Caching Time:
Caching update interval:
Caching update times:
Roaming hops:
SSID employee:
Maximum Caching Time:
Caching update interval:
Caching update times:
No. Supplicant
--- -------------- -------------- --- ----- ----- ----
0 0016:cf8c:57bc 0019:7700:0024 0
This is the same MAC address
for the client (station) that you
saw listed on SmartPath AP-1.
When you see the MAC address of the wireless client that is associated with SmartPath AP-1 in the roaming cache
of SmartPath AP-2, you know that SmartPath AP-1 and -2 are successfully sending data over the backhaul link.
Repeat this to confirm that HiveAP-3 also has a backhaul connection with the other members.
When you see ther MAC address of the wireless client that is associated with SmartPath AP-1 in the roaming cache of SmartPath
AP-2, you know that SmartPath AP-1 and -2 are successfully sending data over the backhaul link.
Repeat this to confirm that SmartPath AP-3 also has a backhaul connection with the other members.
Page 144
Chan Tx Rate Rx Rate Pow
------- ---
1 54M 54M -40
3600 seconds
60 seconds
60
1
3600 seconds
60 seconds
60
Authenticator UID PMK PMKID Life
1349* 1615* -1
This MAC address is for the wifi0.1 subinterface
of SmartPath AP-1, the SmartPath AP with which
the wireless client associated.
Figure 11-6. Show SSID employee station.
724-746-5500 | blackbox.com
A-Mode Cipher A-Time
-------- ------- -------- ---- ---- ---- -------
wpa2-psk aes ccm 00:01:46
Note: On SmartPath APs supporting IEEE 802.11n, there
are two additional columns for SM-PS (spatial multiplexing
power save) and channel width (20 or 40 MHz). The
SM-PS states can be "static" (use one data stream for
11a/b/g clients), "dynamic" (use multiple spatial streams for
11n clients when the SmartPath AP sends an RTS frame),
or "disabled" (always use spatial streams for 11n clients).
Age TLC Hop AL
----- --- --- --
46 195 1
SmartPath AP-1
VLAN Auth UPID Phymode
1 Yes 0 11b/g
SmartPath AP-2
YN