Black Box LWN602A User Manual page 92

Chapter 8: Basic Configuration Examples
After SmartPath AP3 reboots to activate its new configuration, it tries to reconnect with SmartPath EMS. However, it cannot do
so because it is a mesh point that now belongs to the cluster1-test cluster while its portals—SmartPath AP1 and 2—are still
using their original configurations in which they are members of cluster0. This loss of connectivity will continue until you
update the portals, which you do next.
5. Repeat the previous steps to update SmartPath AP1 and SmartPath AP2.
After they reboot and activate their new configurations, check the status of their CAPWAP connections by looking at the
CAPWAP column on the Monitor > Access Points > SmartPath APs page with the View mode set as Monitor. After a few
minutes, all three SmartPath APs will reestablish their connections.
Page 92
724-746-5500 | blackbox.com