Black Box LWN602A User Manual page 129

Table 10-1. Common default settings and commands.
Default Settings
DHCP client = enabled
VLAN ID = 1
mgt0 interface
VLAN ID = 1
wifi0 mode = access
wifi1 mode = backhaul
wifi0 radio profile = radio_g0
wifi1 radio profile = radio_a0
wifi0 and wifi1 interfaces
antenna = internal
channel = automatic selection
power = automatic selection
default-profile:
group ID = 0
User profile
policy name = def-user-qos
VLAN ID = 1
Chapter 10: SmartPath Operating System (OS)
724-746-5500 | blackbox.com
Commands
To disable the DHCP client:
no interface mgt0 dhcp client
To set an IP address:
interface mgt0 ip ip _ addr netmask
To set the native (untagged) VLAN that the
switch infrastructure in the surrounding wired
and wireless backhaul network uses:
interface mgt0 native-vlan number
To set the VLAN for administrative access
to the SmartPath AP, management traffic
between SmartPath APs and SmartPath EMS,
and control traffic among cluster
members:
interface mgt0 vlan number
To change the mode of the wifi0 or wifi1
interface:
interface { wifi0 | wifi1 } mode {
access
| backhaul }
To change the radio profile of the wifi0 or wifi1
interface to a different, previously defined
profile:
interface { wifi0 | wifi1 } radio
profile
string
To have the wifi0 interface use an external
antenna:
interface { wifi0 | wifi1 } radio
antenna
external
To set a specific radio channel:
interface { wifi0 | wifi1 } radio
channel
number
To set a specific transmission power level
(in dBms):
interface { wifi0 | wifi1 } radi0
power
number
You cannot change the group ID or QoS policy
name for the default user profile. To change its
VLAN ID:
user-profile default-profile vlan-id
number
Page 129