Black Box LWN602A User Manual page 164

Chapter 12: Traffic Types
Service Source
SmartPath AP mgt0
SSHv2
interface
SmartPath AP mgt0
TFTP
interface
*Control and provisioning of wireless access points.
†This is the default destination port number. You can change it to a different port number from 1 to 65535.
Service Source
SmartPath Cooperative SmartPath AP mgt0
Control Messages interface
SmartPath Cooperative SmartPath AP wifi1.1
Control Messages or eth0 interface
AeroScout Reports AeroScout engine
SmartPath AP mgt0
DHCP
interface
Ekahau Positioning
Ekahau
Engine (EPE)
SmartPath AP mgt0
interface or
NTP
SmartPath EMS MGT
port
SmartPath EMS MGT
SMTP
port
SSHv2 Management system
SmartPath AP mgt0
syslog
interface
Telnet Management system
TFTP TFTP server or mgt0
* This is the default port number. You can change it to a different port number from 1024 to 65535.
Page 164
Table 12-2 (continued). Traffic supporting management of SmartPath APs.
Destination
SmartPath EMS
SmartPath EMS
Table 12-3. Traffic supporting device operations.
Destination
SmartPath AP mgt0
interface
SmartPath AP wifi1.1
or eth0 interface
SmartPath AP mgt0
interface
DHCP server
SmartPath AP mgt0
interface
NTP server
SMTP server
SmartPath AP mgt0
interface or
SmartPath EMS MGT
port
syslog server
SmartPath AP mgt0
interface
SmartPath AP mgt0
or TFTP server
724-746-5500 | blackbox.com
Protocol SRC Port DST Port
6 TCP 1024–65535 22
17 UDP 1024–65535 69
Protocol SRC Port DST Port
17 UDP 3000* 3000*
N.A. N.A. N.A.
17 UDP 1024–65535 1144
17 UDP 68 67
17 UDP 1024–65535 8552, 8553, 8554
6 TCP 1024–65535 123
6 TCP 1024–65535 25*
6 TCP 1024–65535 22
17 UDP 1024–65535 514
6 TCP,
1024–65535 23
17 UDP
17 UDP 1024–65535 69
Notes
Required for a SmartPath EMS to
upload files—SmartPath OS images,
full configs, captive web portals
pages, certificate—to SmartPath APs
Used for uploading packet capture
files from SmartPath APs to
SmartPath EMS and for loading
SmartPath OS image files from
SmartPath EMS to SmartPath APs
Notes
Required for cluster communications
and operates at Layer 3
Required for cluster communications
and operates at the Logical Link
Control (LLC) sublayer of Layer 2
Required to report tracked devices to
an AeroScout engine
By default, a SmartPath AP gets its
IP address through DHCP.
Required for SmartPath APs to
communicate with EPE
Required for time synchronization
with an NTP server
Required for the SmartPath EMS to
send e-mail alerts to administrators
Used for secure network access to
the SmartPath AP or SmartPath EMS
CLI, and (SCP) for uploading files to
and downloading files from
SmartPath APs
Required for remote logging to a
syslog server
Used for unsecured network access
to the SmartPath AP CLI
Used for uploading files to
SmartPath APs and downloading
files from them