Configuration Utility; Getting Started - Black Box LW6004A Instruction Manual

Pure networking 802.11g wireless access point with switch

Hide thumbs Also See for LW6004A:

Table of Contents

4. Configuration Utility

This access point provides a Web-based configuration tool, allowing you to

configure it from wired or wireless stations. Follow the instructions below.

From a wired station:

1. Make sure your wired station is in the access point's subnet.

The access point's default IP address and subnet mask:

Default IP address: 192.168.2.1

Default subnet: 255.255.255.0

2. Configure your PC to be in the access point's subnet.

2a. Windows 95/98/Me

1. Click on the Start button and select Settings, then click on Control

Panel. The Control Panel window will appear.

2. Double-click on the Network icon. The Network window will appear.

3. Check the Network Components list. If TCP/IP is not installed, click on

the Add button to install it now. If TCP/IP is installed, go to step 6.

4. In the Network Component Type dialog box, select Protocol and click

on the Add button.

5. In the Select Network Protocol dialog box, select Microsoft

TCP/IP, then click on the OK button to start installing the TCP/IP

protocol. You may need your Windows CD to complete the installation.

6. After installing TCP/IP, go back to the Network dialog box. Select

TCP/IP from the list of network components and then click on the

Properties button.

CHAPTER 4: Configuration Utility

and

Table of Contents