Device, Power, And Environmental Specifications - Black Box LWN602A User Manual

Chapter 4: SmartPath AP (LWN602A) Overview
SmartPath AP
(LWN602A)
Instead of passing the cables through a hole in the wall, you can also simply run them along the wall from the port side of the
SmartPath AP, which is located at the top of the device when it is mounted on a wall.
NOTE: You can use a Kensington lock to secure the SmartPath AP to a stationary object. For information, see "Locking the
SmartPath AP" in Section 4.5.1.

4.6 Device, Power, and Environmental Specifications

Understanding the specifications for the SmartPath AP LWN602A is necessary for optimal deployment and device operation. The
following specifications describe the physical features and hardware components, the power adapter and PoE (Power over
Ethernet) electrical requirements, and the temperature and humidity ranges in which the device can operate.
Device Specifications
• Chassis dimensions: 2"H x 6.5"W x 6.5"D (4.6 x 16.3 x 16.3 cm)
• Weight: 1.75 lb. (0.8 kg)
• Antennas: SmartPath AP (LWN602A): two omnidirectional 802.11b/g/n antennas, and two omnidirectional 802.11a/n antennas
• Ethernet port: one autosensing 10-/100-/1000-Mbps port; compliant with the IEEE 802.3af standard and the 802.at standard
for PoE (Power over Ethernet)
Power Specifications
• DC Input: 36 - 57 VDC (48 V/0.3 A)
• PoE input:
• 802.3af
• Pre-802.3at
• RJ-45 power input pins: Wires 4, 5, 7, 8 or 1, 2, 3, 6
Environmental Specifications
• Temperature: Operating: +32 to +104° F (0 to +40° C);
Storage: -40 to +185° F (-40 to +85° C)
• Relative Humidity: Maximum 95% noncondensing
Page 52
1. Position two #6 or #8 screws 2" (5 cm) apart
and fasten them to a secure object such as a
wall, post, or beam.
2. Cut or drill a hole in the wall 1–2"
(2.5–5 cm) above the screws to pass
the cables through to the SmartPath AP.
3. Position the SmartPath AP so that the
screws enter the two upper keyhole-shaped
slots on the underside of the SmartPath AP.
Then push the SmartPath AP downward
to lock it in place.
4. Connect the cables to the SmartPath AP.
Depending on the power source, you might
connect just one Ethernet cable or an
Ethernet cable and a power cord.
Figure 4-8. Mounting the SmartPath AP on a wall.
724-746-5500 | blackbox.com
Wall