Operation - Skyrc iMAX B6 mini Instruction Manual

BATT PROG / STOP Button:
It is used to stop the progress or go back to previous step/screen
DEC Button:
It is used to go through the menus and decrease the parameter value
INC Button:
It is used to go through the menus and increase the parameter value
ENTER / START Button:
It is used to enter parameter or store parameter on screen.
When you are willing to alter the parameter value in the program, press the
START/ENTER button to make it blink then change the value by pressing DEC and
INC button. The value will be stored by re-pressing the START/ENTER button. If
there is another parameter can be altered in the same screen, when you confirm the
first parameter value, the next parameter value will start to blink which means it is
ready to alert.
When you are willing to start the progress, press and hold the START/ENTER button
for 3 seconds. When you are willing to stop the progress or go back to previous
step/screen, press the BATT PROG/STOP button once.
When you power on the charger, it will enter LiPo Battery balance program directly.
You could change the mode (balance mode, normal charge mode, fast charge mode,
store mode or discharge mode), enter the desired charging/discharging mode, set
the referred parameter and start the progress.
If you have no request for LiPo Battery program, please press the BATT
PROG/STOP button to enter BATT PROGRAM screen.
B6 mini

OPERATION

09 ·