Table of Contents
Advertisement
To update the MAC address, proceed as follows:
▶ After replacing a network controller or the system board, switch on and boot
the server, see
The hardware configuration tool for Red Hat Linux, will launch at boot and
detect the new and/or changed hardware on your system.
▶ For the changes to take effect, you need to reboot the network by entering
the following command:
# service network restart
If the system board or network controller offers multiple LAN ports, it
is necessary to update the remaining ifcfg-eth<x> definition files
accordingly.
▶ Update the NIC configuration file to reflect the new card sequence and MAC
address.
5.2.7
Performing a RAID array rebuild
After replacing an HDD that has been combined into a RAID array, RAID
rebuild will be performed completely unattended as a background process.
▶ Ensure that the RAID array rebuild has started normally. Wait until the
progress bar has reached at least one percent.
▶ Inform the customer about the remaining rebuild time, based on the
displayed duration estimate.
GX2570 M6
"Switching on the server" on page
Upgrade and Maintenance Manual
Basic software procedures
49.
75
Advertisement
Table of Contents
