Leveling The Amt - Precor P30 Operating And Maintaining

Assembling the AMT

Leveling the AMT

It is important that you level and stabilize the AMT properly
every time you move it.
CAUTION: To eliminate movement, make sure the adjustable feet
are in contact with the floor. Also, make sure that the unit sits on
a flat surface. Adjusting the feet of the unit cannot compensate
for extremely uneven surfaces.
To level the AMT:
1.
2. Using a ⁹₁₆-inch open-ended wrench, move the jam nuts
Gently rock the AMT while standing on one of its foot
plates and grabbing the opposite handlebar. First stand on
the left foot plate and grab the right handlebar to rock the
AMT, then repeat the step while standing on the right
foot plate and holding the left handlebar. If there is any
movement, ask your assistant to tip the unit on its side
while you locate the adjustable feet.
Note: Alternatively, place the angled end of a 12" pry bar
against the underside of the back frame tube at its end,
then press the straight end of the pry bar against the floor
to lift the back of the AMT a few inches.
away from the side arm supports and toward the
adjustable feet.
37