Precor P30 Operating And Maintaining page 24

22
The equipment is in the Welcome state when it is on, but not
actually in use. This means that there is no exercise session,
data entry, or diagnostic operation in progress.
When the equipment is in the Welcome state:



Note: On self-powered equipment, the console initializes
when you begin working out. You must maintain a minimum
rate of motion for the Welcome banner to appear.
The changes made in System Setting modes become the
default settings when the display resets to the Welcome
banner.
CAUTION: If you change the Unit of Measure display on the
treadmill, check the speed setting to verify that it is correct.
To view the Club Parameters settings:
1.
2. Press the following number keys in sequence to enter the
3. Press OK.
Table 2. Navigational keys for the system setting modes
Key
L or M
OK
BACK
PAUSE
PRECOR scrolls on the lower text display. SELECT A
WORKOUT OR PRESS QUICKSTART TO BEGIN scrolls
in the upper text display.
The heart rate signal is the only segment activated.
On the treadmill, the belt is not moving and the lift motor
is off.
At the Welcome banner, press Pause.
password:
5 6 5 1 5 6 5
The Set Club Parameters banner appears.
Function
Navigates the settings menu
Selects a menu setting
Returns to the previous menu level without saving
changes
Exits the System Settings mode and returns to the
Welcome banner
Operating and Maintaining the P30 Console