Adding The Side Arm Supports - Precor P30 Operating And Maintaining

20

Adding the Side Arm Supports

In the next procedure you will need the following pieces of
hardware:








Important: The side arm supports are shipped with foam blocks
inserted in one end. These blocks are provided to prevent fasteners
from falling into the supports. Do not remove the foam blocks or
push them down into the supports.
To add the side arm supports:
1.
2. Insert two ⁵₁₆-inch x 1-inch hex head machine screws
Assembling and Maintaining AMT 800-Series Adaptive Motion Trainers
Two side arm supports
Two inner side arm covers
Two outer side arm covers
Six #10 x 1¹₄-inch self-tapping screws
Six ⁵₁₆-inch x 3¹₂-inch hex head bolts
Six ⁵₁₆-inch nylon lock nuts
Six ⁵₁₆-inch flat washers
Four ⁵₁₆-inch x 1-inch hex head machine screws
Place the upper end of the right-hand support against the
right-hand side arm.
(with washers attached) into the two holes underneath
the side arm support bracket and tighten partially.
Figure 2: Machine screw attachment to install side arm
support