Required Tools; Unpacking The Amt - Precor P30 Operating And Maintaining

Assembling the AMT

Required Tools








Unpacking the AMT

DANGER
CAUTION: Do not climb onto the AMT until directed to do so.
Follow these steps to remove the AMT base unit from its
shipping container.
To unpack the AMT:
1.
2. Remove and discard the fastener securing the back of the
3. Remove and discard the bolts and nuts securing the
4. Remove the fasteners securing the wooden supports to
5. Cut and remove the plastic ties, bubble wrap, and foam
#2 Phillips screwdriver
Rubber mallet
SAE standard socket set
Wire cutter
Two #1 Phillips screwdrivers
Torque wrench (calibrated in inch-pounds, and including
³₁₆-inch hex wrench bit)
Do not attempt to connect electrical power until
all assembly procedures are complete and the
console is properly installed.
Remove the rear pedestal and set it aside.
center support to the shipping pallet.
wooden supports to the side arms of the AMT.
the shipping pallet, then discard the supports and the
fasteners.
Important: In the following step, do not force the foam block
placed around the center support. Doing so may damage the
plastic cover on the center support. Instead, slide the foam
block backward until you have removed it from the plastic
cover, then lift it out of the way.
blocks securing the unmounted parts inside the shipping
container.
19