Precor P30 Operating And Maintaining page 77

Assembling the AMT
8. On the opposite side of the center support from the
9. Adjust the side arm supports as needed, then tighten all
10. Extend the adjustable feet on the side arm supports until
handles of the screwdrivers, insert the four ⁵₁₆-inch x
3¹₂-inch hex head bolts. Attach a ⁵₁₆-inch nylon lock nut
to each bolt. Partially tighten the fasteners, then remove
the screwdrivers.
Figure 6: Lower side arm attachment
of its fasteners to 160 inch-pounds of torque.
they touch the floor, then remove the spacer block from
under the back end of the AMT.
Note: If necessary, use a ⁹₁₆-inch open-ended wrench to
loosen the jam nuts on the adjustable feet.
23