Precor P30 Operating And Maintaining page 75

Assembling the AMT
3. Slide one ⁵₁₆-inch flat washer and one ⁵₁₆-inch sleeve over
4. Insert the ⁵₁₆-inch x 3¹₂-inch hex head bolt, with the
5. Repeat steps 1 through 4 to attach the left-hand side arm
one of the ⁵₁₆-inch x 3¹₂-inch hex head bolts.
Figure 3: Adding the sleeve and washer
washer and sleeve, into the screw hole on the inside of the
right-hand side arm. Attach a ⁵₁₆-inch nylon lock nut to
the end of the bolt and tighten partially.
Important: Be sure to insert the bolt into the inward side of
the side arm and apply the nut to the outward side, as shown
in the following figure. If the bolt is inserted in the other
direction, the side arm covers will not fit. Do not tighten
fasteners completely until instructed to do so.
Figure 4: Bolt and sleeve attachment to install side arm
support
support to the left side arm.
21