Precor P30 Operating And Maintaining page 84

30
3. Insert the connectors into the jack plate at the lower front
4. Replace the nut that you removed from the television
5. Plug the Ethernet cable into the inside jack on the
6. Connect the television cable to the inside end of the
Assembling and Maintaining AMT 800-Series Adaptive Motion Trainers
of the AMT, as shown in the following figure and table.
Figure 15: Jack plate layout
Table 1. AMT connector locations
Position Connector
Ethernet coupler (P80 console only)
Television cable coupler (P80 console only)
Console power cable (P80 console only)
External power connector for base unit (optional)
Important: In the following step, do not overtighten the
connector. Finger-tighten it until it is snug, then use the
wrench to tighten it only slightly (8 to 9 inch-pounds).
cable coupler in step 2, then tighten it slightly using a
⁷₁₆-inch open-end wrench.
Ethernet coupler.
television cable coupler. Tighten the connector slightly
using a ⁷₁₆-inch open-end wrench.