Adjusting The Sealing Strips - HAKO Hakomatic B 650 R Instruction Manual

5. Take into operation

5.6.3 Adjusting the Sealing Strips

Angle Adjustment
The angle adjustment is the decisive
factor in ensuring that the sealing
strips on the squeegee lie evenly on
the floor.
1. Park the machine on a level surface
and lower the squeegee.
2. Loosen the counternut on the screw
(Fig. 1/3) and adjust the squeegee
using the counternut so that the
ends of the sealing strips still have
contact with the floor.
Figure A
Turn the counternut counterclock-wi-
se: The clearance between seal-ing
strip and floor is reduced in the cen-
tre.
Figure B
Turn the counternut clockwise: The
clearance between sealing strip and
floor is increased in the centre.
3. Switch the machine on and check
the suction pattern. When the ma-
chine is in operation, the entire sur-
face of the sealing strips (centre and
outer areas) must be applied as
evenly as possible.
4. Tighten the counternut on the ad-
just-ing screw at 5 lb ft.
A
B
Fig. 2
23