First Operation; Instruction; Prior To Starting Up; Start Machine - HAKO Citymaster 90 Instruction Manual

First Operation

2 First Operation
2.1

Instruction

Instruction is required before first
operation. First instruction into handling
of the machine must be held by a
qualified person sent by your local
PowerBoss contract dealer. Your
PowerBoss dealer will be informed by
the manufacturer upon delivery of the
vehicle and will contact you to make a
date for instruction.
2.2

Prior to starting up

Carry out the following checks before
starting the vehicle:
1. Check the engine oil level, fuel level,
coolant level, hydraulic oil level,
solution level, sweepings container
and tire pressure; refer to Chapter
"Maintenance".
2. Check the position of the driver's
seat, refer to Section 3.2.
3. Check the position of the wing mirror
(only with the weatherproof roof
option).
18
2.3

Start Machine

Before starting the machine
you are advised to read and
comply with the Provisions of
Operating from Safety
Information chapter!
Before start to ride, subsequently ac-
tuate the following control elements:
1. Set all operating levers and switches
to neutral, see paragraph 3.2.
2. Secure the vehicle by engaging the
parking brake.
3. Start engine with ignition switch, see
paragraph 3.2.
- After the motor has started, the en-
gine oil pressure and charge status
lamps have to extinguish.
If the ambient temperature is
-10° C and less let the engine
run idle for about 20 minutes
(warm-up). At an ambient
temperature of +10° C and
more a warming-up is not
necessary.
4. Preselect engine speed governor,
see paragraph 3.2.
5. Release parking brake.
6. Slowly depress pedal of desired di-
rection and the vehicle starts rolling.