First Operation; Instruction; Initial Charging Procedure; Before Putting Into Operation - HAKO Hakomatic B45 Instruction Manual

First Operation

2 First Operation
2.1

Instruction

Instruction is required before first ope-
ration. First instruction into handling of
the machine must be held by a qualified
person sent by your local PowerBoss
contract dealer. Your PowerBoss dea-
ler will be informed by the manufacturer
upon delivery of the vehicle and will
contact you to make a date for instruc-
tion.
2.2

Initial charging procedure

Before first operation of the
machine, fully charge the bat-
tery with an initial charging pro-
cedure and comply with the
operating instructions of the
charger as well as with those of
the battery manufacturer.
PowerBoss cannot be held lia-
ble for damages resulting from
an insufficient initial charge.
10
2.3

Before Putting into Operation

Complete the following inspections be-
fore taking the machine into operation:
1. Check the area around the machine
for signs of leakage. Hoses, lines
and tanks must be free from any lea-
kage or damage.
2. Install brushes and squeegee, see
maintenance chapter.
3. Install batteries and connect battery
plug, see maintenance chapter.
4. Check battery charge and proceed
to re-charging of batteries if required.
Generally proceed to initial charging
before first operation of the machine.
5. Empty recovery tank and clean it if
required, see maintenance chapter.
6. Re-fill solution tank and add cleaning
agent according to the manufactur-
er's recommendations.
Use only cleaning agents sui-
table for automatic machines
(low-foaming) and comply with
the instructions for use, dispo-
sal and with the warning infor-
mation specified by the cle-
aning agent's manufacturer.
2.4

Switching the machine on

Before switching the machine
on, please read the safety in-
formation in Chapter 1.
Carry out the following preliminary work
so that the machine is ready to operate:
• If necessary, disconnect the power
plug of the charging device from the
socket and place it in the holder. If
the power plug is not inserted pro-
perly in the holder (Fig. 2/1), the ma-
chine is not ready to operate!
1
Fig.2