No Line Seizure; Wiring The Power Transformer; Powering Up The Panel; Installing The Panel Backup Battery - GE Simon Installation Instructions Manual

Note
Connecting the panel to a
standard phone (voice) line
in this manner should be
avoided. Other devices in
use at the same time the
panel is using the line can
prevent reports from going
through.
Note
Do not plug in the trans-
former at this time
Simon Security System

No Line Seizure

This method is typically used where DSL (digital subscriber line) service exists. DSL
allows multiple devices on a single phone line to be used simultaneously. Simply con-
necting the panel LINE IN jack to an available phone jack on the premises is all that is
required.
An in-line filter may be required to ensure panel reporting is successful.
* For UL installations, installer needs to verify line seizure.

Wiring the Power Transformer

Connect the power transformer to the panel AC terminals as shown in Figure 10.
A C A C H W I N 2
Figure 10. Connecting the Power Transformer

Powering Up the Panel

When applying power to the panel connect the battery first, then plug in the AC power
transformer. This sequence prevents a battery fault condition.

Installing the Panel Backup Battery

1. Position and push the battery between the 2 flexible tabs (A in Figure 11).
2. Slide the battery to the left until the tabs snap into place, securing the battery (B in
Figure 11)
A
-
Tabs
+
+ -
Figure 11. Installing the Panel Backup Battery
3. Connect the red and black battery leads (included with panel) to the battery and
panel terminals (see Figure 12 A - Open Battery / B - Covered Battery).
Connecting the Battery Leads to the Battery and Panel Terminals (see Figure 12).
D C O U T H W I N 1
B
-
+
+ -
14