X10 Module Operation - GE Simon Installation Instructions Manual

Note
For a more specific location
name, press Option # for
compass directions (north,
northeast, east, southeast,
south, southwest, west,
northwest).
Note
If you wish to use a sensor
number other than the next
one available, use the num-
bered keys to enter a 2 digit
sensor number immediately
after entering the sensor
type.
Simon Security System
When adding (learning) sensors, the panel uses an ascending numbering sequence
starting with 1. You can override this by entering the desired sensor number using the
numbered keys.
Use the Table in Appendix B, which was filled out during the system planning, to help
program sensors.
¾ To add a hardwire or RF sensor or remote control:
1. Press Add. The panel announces "Select from Main Menu."
2. Press Sensor/Remote. The panel announces "Press button on sensor."
3. Press the sensor program button or release sensor tamper switch. The panel
announces "Keychain Remote. Press sensor again for next name or press Done to
select."
4. Press Sensor/Remote repeatedly until you hear the name or item you want to use.
An alphabetical list of names the panel uses appears in Appendix B. Each name
may be used more than once.
5. Press DONE when you hear the desired name. The panel announces "Use num-
bered keys to enter sensor group."
6. Enter the 2-digit sensor group. The panel announces the sensor group and the first
available sensor number, then prompts you to press DONE to accept.
7. Press DONE. The panel confirms programming by announcing the sensor num-
ber, name, and group.
Version 3
* Press for program
information.
Light
Control
*
Unit #
*
4
Instruction
Summary
Add Option
Option #1: Panel Beeps
Option #2: Panel Voice
Option #3: Latchkey Time
Option #36: Sensor Activated Light Lockout Start Time
Option #37: Sensor Activated Light Lockout Stop Time
Option #41: Chime Voice
Option #42: Speaker Volume
Option #43: Pager Phone Number
Option #55: Status Beep Volume
Add Option #
Press and follow voice prompts.
See Note
¾ To delete sensors:
1. Press Delete. The panel announces "Select from Main Menu."
2. Press Sensor/Remote repeatedly until you hear the name and number you want
deleted, then press DONE. The panel announces that the sensor is deleted.

X10 Module Operation

Use the following procedure to program X10 module operations into panel memory.
Notice that the Light Control button is used to program all X10 module operations
(light, appliance, and universal).
¾ To program the house code:
START MENU
Add Delete Cancel Test
MAIN MENU
Sensor/ Access
Option # Remote Code
* *
0 1 2
CONTROL MENU
Entry/Exit
Delay Sensors Time -
* *
5 6 7
- Minutes +
DONE
Add Access Code
Add Access Code DONE
Press
See Note
use red numbers to enter 4-digit code.
Set Clock
Clock Set Hours Minutes
Press
See Note
System should be checked
by a qualified technician
at least every three years.
Clock
Set
3
Note:
Hold key or press
Hours +
repeatedly until you
hear the desired item.
8 9
Delete
To delete an option or access code
Delete
press and follow the voice
prompting.
Cancel
If you make a mistake or want to
, then
Cancel
start over press
Sensor or Phone Test
Test
DONE
To select a test, press and
follow the voice prompting.
18