Advertisement
Upper temperature limit This sets the highest temperature setting the
TPI cycles per hour
Optimum start
Tamper setting
Set up Z-Wave
SCS311 or SCS317 will allow to be
programmed
Default setting is 30˚C
This setting helps the TPI energy saving
software to operate correctly depending on
the type of heating system you have
This calculates the amount of time the
SCS311 or SCS317 may need to switch on
in advance of the next target temperature
setting in order to meet the requirement
This setting allows a 4 digit release code to
be set up to stop unauthorised adjustments
being made in multi occupancy buildings
Sub Menu
Include node / receiver Include other devices
Exclude node / receiver Remove devices from
Send NIF
Learn
Description
onto the network.
a network.
Sends a Node
Information Frame
(NIF) as a broadcast
message.
Used for inclusion or
exclusion by another
controller. This mode
can be used for the
reception of the
primary controller role
following a controller
shift initiated by the
current primary
controller.
6
Advertisement
