Power Meters & Monitors; Touch Screen Encoders & Buttons - SoundCraft Si Compact User Manual

Hide thumbs Also See for Si Compact:

Table of Contents

POWER METERS AND MONITORS

1. 12V LAMP OUT: Connector for LED or similar console light; maximum total load 100 mA

2. USB: Insert USB key for loading and backup of shows, software updates and similar.

3. POWER: Toggles console power ON/OFF. To prevent accidental shut-down a 2-stage

4. MONITOR meters: Indicate the level in the engineers monitor system; this is normally

5. L, R and MONO meters: Full-time uninterrupted monitoring of the main Left, Right and

6. SIP , PFL & AFL indicators: Illuminates to show the current mode or active state of the

TOUCH SCREEN ENCODERS AND BUTTONS

1. TOUCH SCREEN: colour touch screen

2. MENU key: Press when lit to return

3. APPLY key: Press when lit to 'APPLY'

4. SCROLL/ADJUST encoder: Rotate to

Soundcraft Si Compact User Guide 0311

per socket.

shut-down procedure is required:

Press & Hold the POWER ON key for ~2 seconds, the power light will flash orange.

Confirm shutdown by pressing the POWER ON key again whilst the light is flashing.

If the confirmation is not received within ~5 seconds the POWER ON key will revert to

solid green and the shutdown procedure is cancelled.

the LR signal but may be PFL/AFL, or other signal as set in the MONITOR system menus.

MONO buses.

SOLO system.

interface.

to the MAIN MENU page.

a change such as re-naming a cue,

channel, show or similar.

scroll up/down lists, press to select

or activate a highlighted function.

Table of Contents