Table of Contents
Advertisement
Configuring Your PC Card
PhoenixCARD Manager Plus (PCM+)
To attain compatibility with as many PC cards as possible, the PDT 3200 utilizes card and
socket services supplied by Phoenix Technologies. These card and socket services are im-
plemented as installable device drivers and are loaded using the DEVICE= command in
the CONFIG.SYS Þle.
Table 4-1 identiÞes the PhoenixCARD Manager Plus (PCM+) drivers needed for each type
of card. Information about these drivers follows the table. Additional drivers or applica-
tion programs may be required for some cards, particularly RF, LAN, and fax/modem
cards.
PCM+ Driver
CNFIGNAM.EXE
PCM.INI
PCMATA.SYS
PCMCS.EXE
PCMSCD.EXE
PCMSS.EXE
¥ CNFIGNAM.EXE identiÞes the section in the PCM+ conÞguration Þle
(PCM.INI) that should be loaded as the default.
¥ PCM.INI is the conÞguration Þle for the PC cards.
¥ PCMATA.SYS is an ATA-IDE device driver. It communicates with the
PCMCS.EXE driver to allow the system to access ATA-conÞgured PC cards.
¥ PCMCS.EXE is the card-services driver. Required for all PC cards, it provides an
interface between applications and the socket services. It also manages resource
allocations for the PC cards.
¥ PCMSCD.EXE is referred to as the super client driver. It uses the PCM.INI Þle to
conÞgure and request system resources for generic PC cards as well as speciÞc
cards that have been included in the PCM.INI Þle. Some PC cards will have
Table 4-1. PCM+ Drivers Required for PC Cards
ATA
X
X
X
X
X
Chapter 4: Using PC Cards
Fax/
LAN
Modem
X
X
X
X
X
X
X
See Below
X
X
RF
X
X
X
X
4-5
Advertisement
Table of Contents
