Table of Contents
Advertisement
PDT 3200 Technical Reference Guide
The CONFIG.SYS and AUTOEXEC.BAT Þles contain only basic commands that the unit
needs to run correctly (see Figure 1-1 and Figure 1-2). Both Þles chain to their respective
counterparts on the B drive, as described in the next section.
The CONFIG.SAF Þle (see Figure 1-3) is used in the safe-boot sequence. For more informa-
tion about the CONFIG.SAF Þle, see page 1-5.
REM ************************************************
REM Initial CONFIG.SYS file for starting the system.
REM ************************************************
NEWFILE = B:\CONFIG.SYS
@echo off
REM **************************************************
REM Initial AUTOEXEC.BAT file for starting the system.
REM **************************************************
VER
PATH=A:\
B:\AUTOEXEC.BAT
REM *********************************
REM Initial CONFIG.SYS for safe boot.
REM *********************************
NEWFILE = B:\CONFIG.SAF
Drive B
Drive B is a disk image that is located in ßash. A read-only drive, it is intended to be used
to store mandatory utilities and initialize the boot process. During normal use this drive
will not be updated. Drive B includes the following Þles:
¥ AUTOEXEC.BAT, the second Þle in the startup sequence
¥ CFGDEV.SYS, the system parameter conÞguration device driver
1-4
Figure 1-1. CONFIG.SYS File on Drive A
Figure 1-2. AUTOEXEC.BAT File on Drive A
Figure 1-3. CONFIG.SAF File on Drive A
Advertisement
Table of Contents
