Table of Contents
Advertisement
PDT 3200 Technical Reference Guide
XFER.EXE
The XFER utility gives you the ability to transfer Þles to and from a PC through the PDT
3200Õs serial port.
Syntax
XFER [/ option1 [/ option2 ] ...] filename
Options
/1|2
Sets the communication port (COM1 or COM2) to use.
/a
Receives data and appends it to the speciÞed Þle. If you do not use this option, the Þle will
be overwritten. This option is available only when used with the /p option.
/b #
SpeciÞes the baud rate. Acceptable settings are 2400, 4800, 9600, 19200, 38400, 57600, and
115200; the default is 19200.
/d #
If used with the /p option, this option speciÞes the receive timeout, in seconds. Replace
the # symbol with the desired number of seconds for the timeout.
If used with the /s option, this option speciÞes the delay between packets, in 55-millisec-
ond intervals. Replace the # symbol with the desired number of delay intervals.
The range of acceptable values for # is 0 to 65,535. If neither /p nor /s is speciÞed, this op-
tion is ignored.
/h
Displays a help Þle for the XFER command.
/o
Overwrites the speciÞed Þle without prompting. If this option is not used and the Þle-
name exists, the following message and prompt will be displayed:
ÒThe file exists. Overwrite? (Y/N)Ó
2-12
Advertisement
Table of Contents
