Motorola MP6000 Integrator Manual page 178

5 - 24 MP6000 INTEGRATOR GUIDE
Beeper and LED Indicators (Continued)
Table 5-1
Condition Beeper Indication
BELL (RS-232) High Beep
Volume
Pressed and Annunciates volume
release level
Volume/Tone
button
Press and hold Annunciates decode
Volume/Tone tone
button for two
seconds
Decode tone Button click; decode
change beep at next tone
(wrap)
(Describes action
above)
System LED Button LED
Indication Indication
None No change
No change Button LED
blinks for two
seconds (at 2
Hz)
No change Button LED
blinks for two
seconds
No change No change
Description
A <BEL> character is received
over RS-232.
Volume change: causes the
current volume level to be
annunciated. If pressed within two
seconds of the previous (or while
volume LED is blinking), it
annunciates the volume at the next
level. Once the maximum volume
level is reached, it wraps and
begins at the lowest volume level.
Decode tone changes
Subsequence decode tones are
heard every second if continuously
held. Decode tones cycle.
After holding the Volume button for
two seconds, the next decode tone
sounds. For each additional
second the decode tone changes
again.