Motorola MP6000 Integrator Manual page 122

3 - 32 MP6000 INTEGRATOR GUIDE
Lowering the Short, Medium, Long MP6000 into the Counter
Figure 3-41
Replace the platter.
c.
Ensure the device is seated properly - see (i) for Long and (ii) for Medium and Short
d.
Long MP6000: The long MP6000 should not rock on the checkstand's adjustable supports
i.
(screws), and the platter must be flush with the surrounding checkstand. If the MP6000 rocks,
remove it, and adjust the checkstand supports (screws). If the MP6000 still rocks, continue to
remove the device and adjust the supports until it sits solidly in the checkstand.
When the platter is flush, its leading edge should be slightly below the checkstand, and the trailing
edge should be slightly above the checkstand.
Short Unit
Medium Unit
Long Unit
Counter
Under Counter
Foot Rest
Under Counter
Foot Rest