Audit Tallies - Motorola MP6000 Integrator Manual

The weight checked at each position on the scale, shown in
of the platter and corner. Use a stack configuration of weights if needed (i.e., (2) 5.00 lb weights, or (2) 2.500 kg
weights) depending on the units of measure programmed.
Weight Positions on the Scale Platter
Figure 4-4
While performing a shift test, the indication of each position is within the applicable tolerance and the range of
results obtained should not exceed twice the applicable tolerance.
IMPORTANT After verification, record/report audit trail information to the local Weights and Measure authority
where required by law.

Audit Tallies

Audit Tallies (calibration counter = C, legal parameter counter = P) used for scale verification can be shown on
the Scale Display, or the 7-segment display.
Press and hold the Scale Zero button for three seconds to access the calibration tallies (not within
1.
Calibration mode).
C### and P###
a.
C###
represents the number of times the scale reached
i.
successful calibrations are counted.)
The P###
ii.
changed with or without reaching
SCALE CALIBRATION (MODELS WITH A SCALE ONLY) 4 - 11
Shaded Area
Represents the
Horizontal Window
Scale Platter
tallies blink on the Scale Display and/or scroll on the 7-segment display.
represents the number of times any sealable parameter, or legal parameter was
Calibration Success on page
Figure 4-4, represent halfway between the center
Calibration Success on page
4-7.
4-7. (Only